HONDA DT18 - Manual (Page 44)

42 – English
2.
A) Attach the chute assembly (G) to the machine
with three 1/4"-20 round head screws (H)
above and two 1/4"-20 hex bolts (J) on the
side (see illustration). It is easier if you remove
the clutch cable adjustment unit.
B) Refit the wheels with the catcher tray wheel
plate (I).
C) Fit the catcher plate to the machine by
inserting the hooks from the plate into the
catcher bag wheel plate.
ASSEMBLY INSTRUCTIONS
Assembly directions, catcher bag
DT18
1.
Remove both back wheels (F), the wheel plate (E)
with accessories. Remove the guard (B), the
neoprene deflector (C) and the deflector strap (D)
by removing the ten (6 + 4) slotted screws.
A. Slotted screws
B. Guard
C. Neoprene deflector
D. Deflector strap
E. Wheel plate
F. Back wheels
WARNING!
Do not use or start the engine
until the catcher bag is in place.
8011-010
8011-011
G. Chute assembly
H. 1/4"-20 round head screws
I. Wheel plate for catcher bag
J. 1/4"-20X 5/8" hex bolt
D) Fit the catcher bag to the frame as follows:
• Affix the bag’s plastic rails to the frame.
• Thread the upper portion of the bag between
the two struts on the upper portion of the frame
and affix the bag to the front edge of the frame.
• Press on the snaps, one on each side.
8011-283
8011-284
(P/N 540000061)