Hypertec ISDN 10T Router - Manual (Page 50)

Configura
43
IP Mask of Remote Ethernet
The remote IP mask is used to describe the remote IP sub-netting. The IP mask is entered by clicking the
IP address bit map. The number of bits assigned for the IP subnet is shown next to the IP address bit map
as a decimal number, for your reference.
Local End IP Address of ISDN Line
This field specifies the local end of the IP address of an IP connection. This field is applicable to the
“numbered interface” IP address setting.
Remote End IP Address of ISDN Line
This field specifies the remote end of the IP address of an IP connection. This field is applicable to the
“numbered interface” IP address setting.
IP Mask of ISDN Line
This field specifies the IP mask of the ISDN line when the “numbered interface” IP address scheme is
used. Both local end and remote end should use the same IP mask.
Internet NAT Sub-menu
The Internet NAT sub-menu (see fig 4.12) is used to configure the NAT feature. NAT is a feature
designed for security protection and cost saving for Internet access. NAT hides internal IP addresses
from the outside world therefore decreasing the possibility of hacker attack. NAT translates the
internal IP addresses into a single IP address for Internet access. If the number of IP address assigned
by the ISP is a factor for billing, NAT can save the monthly bill.
Figure 0-10, Internet NAT Window