Hypertec ISDN 10T Router - Manual (Page 7)

Introduction
7
About this Manual
Chapter 2, Installation. This chapter provides details of how to install the Hypertec ISDN Router
hardware and software. Guidance is provided about the ISDN line that is required from your telephone
company and the personal computer requirements to use the Network Management System software.
Chapter 3, Concepts and Principles of Operation. This chapter covers the concepts and principles of
operation of three major topics : ISDN, Data Services, and voice services. The Hypertec ISDN Router
operation principles in the area of Internet/Intranet profiles, and bandwidth management are discussed in
detail. This chapter also includes information about ISDN line provisioning.
Chapter 4, Set-up and Configuration. This chapter provides details of how to setup and configure your
Hypertec ISDN Router for operation. This chapter provides brief details of how to perform this from a
console or from a Browser. Full details are provided for the recommended method of setup and
configuration from the NMS software provided with the Hypertec ISDN Router.
Chapter 4, Troubleshooting. This chapter provides troubleshooting procedures in the unlikely event that
Hypertec ISDN Router does not function properly.
An index is provided at the end of the manual.
Hypertec ISDN 10T Router Packing List:
Your Hypertec ISDN 10T Router should contain the following:
•
The Hypertec ISDN 10T Router
•
Diskette : NMS software
•
Express Route Manual
•
ISDN Cable: RJ45!Black color, 4 copper wire with different color, 6 feet"RJ45
•
DB cable: DB9 female!1.4meter "DB9 male
•
DB converter: DB9 male !"DB 25 female
•
Power Adapter: Output rate at 15DVC 600mA