Hypertec ISDN 10T Router - Manual (Page 8)

Installation
1
INSTALLATION
General
The Hypertec ISDN 10T Router is shipped in a box, which contains the following items:
•
The Hypertec ISDN 10T Router
•
One Power Adapter with cable
•
One ISDN cable, 6 foot long with an RJ45 connector at each end
•
One data cable with a DB9 connector at each end
•
One changer DB9 (male) to DB25 (female)
•
Two 3 1
/
2
” diskette containing the Hypertec ISDN 10T Router NMS software
•
One 3 1
/
2
” diskette containing the Hypertec ISDN 10T Router EasyWeb software
•
This Hypertec ISDN 10T Router user manual
Check the contents of the box and ensure that everything is included. If there are any items that are
missing or appear to be damaged, replace all the items back in the box and contact your sales
representative.
Hardware Installation
Before installing the hardware, you will need:
A 100 to 230 VAC wall outlet within a few feet of where you intend to place the Hypertec ISDN
10T Router.
An ISDN BRI line RJ45 termination within a few feet of where you intend to place the Hypertec
ISDN 10T Router.
If you intend to connect an analog modem, telephone or fax to your Hypertec ISDN 10T Router,
you will need a standard RJ11 telephone cable for each of the connected devices.
Each Ethernet LAN connection to the Hypertec ISDN 10T Router must use a normal straight
through twisted pair cable with an RJ45 connector. If the LAN employs coaxial cable, an adapter
converting the coaxial cable to a twisted pair RJ45 cable must be used.
All connections during the hardware installation are made at the Hypertec ISDN 10T Router rear
panel shown in Figure 0-1, Hypertec ISDN 10T Router Rear Panel.
Power Phone1Phone2 ISDN
Console
Ethernet
DIN RJ 11 RJ 45 DB 9 RJ 45
Power
Cord
To FAX or
Telephone
Lines
To ISDN
Line
To Ethernet Hubs
or Stations
To PC or Terminal
Console
Figure 0-1, Hypertec ISDN 10T Router Rear Panel