Hitachi CP-X505 - Manual (Page 29)

9
IMAGE Menu
IMAGE Menu
Item Description
ASPECT
Using the ▲/▼ buttons switches the mode for aspect ratio.
For an RGB signal
NORMAL у 4:3 у 6:9 у SMALL
For an M1-D signal
NORMAL у 4:3 у 6:9 у 4:9 у SMALL
For a Video signal, S-video signal or Component video signal
4:3 у 6:9 у 4:9 у SMALL
For no signal
4:3 (fixed)
• The NORMAL mode keeps the original aspect ratio of the signal.
OVER SCAN
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
V POSITION
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when the V POSITION
is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal,
or component video signal of 55i (480i) or 65i (576i), the range of
this adjustment depends on the OVER SCAN (above) setting. It is
not possible to adjust when the OVER SCAN is set to 0.
H POSITION
Using the ▲/▼ buttons adjusts the horizontal position.
Left ó Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to the
default setting. Pressing the RESET button when the H POSITION is
selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal,
or component video signal of 55i (480i) or 65i (576i), the range of
this adjustment depends on the OVER SCAN (above) setting. It is
not possible to adjust when the OVER SCAN is set to 0.
From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the item. Then perform it
according to the following table.
/'07=4)$?
+/#)'

2+%674'


 5'.'%6

#761#&,756':'%76'

#52'%6 

18'45%#0

*2*#5'

*5+<'

*215+6+10
 
 

8215+6+10

5'672

+0276

5%4''0
126+10
#7&+1
0'6914-
'#5;/'07
(continued on next page)