Hitachi CP-X505 - Manual (Page 46)

46
Item Description
SERVICE
KEY LOCK
Using the ▲/▼ buttons turns on/off the key lock feature. When
TURN ON is selected, the buttons on the projector except the
STANDBY/ON button are locked.
TURN ON ó TURN OFF
• Please use to avoid a mischief and touching accidentally. This
function does not have any effect on the remote control.
REMOTE RECEIV.
(1) Select a remote sensor using the ▲/▼ button.
:FRONT ó :TOP ó 3:REAR
() Switch it using the ENTER button
¨ (off) у ю (on)
• A sensor cannot be turned off when the other
two are off. Always at least one sensor is on.
REMOTE FREQ.
Use the ▲/▼ button to change the Projector's remote sensor
setting (14).
:NORMAL ó :HIGH
Items with a checkmark are on. The factory
default setting is for both :NORMAL and :
HIGH to be on. If the remote control does not
function correctly set the this to either only
 or only  as described in Remote Control
Settings (14).
Neither can be turned off at the same time.
INFORMATION
Selecting this item displays a dialog titled “INPUT INFORMATION”.
It shows the information about the current input.
INPUT-INFORMATION
RGB
04x768 @60Hz
FRAME LOCK
INPUT-INFORMATION
S-VIDEO
SECAM
AUTO
INPUT-INFORMATION
COMPONENT
576i @50
SCART RGB
• The “FRAME LOCK” message on the dialog means the frame lock
function is working.
• The “SCART RGB” message means the COMPONENT VIDEO
port is working as a SCART RGB input port. Please refer to the
COMPONENT item in INPUT menu (32).
• This item can't be selected for no signal and sync out.
FACTORY RESET
Selecting RESET using the button ▲ performs this function. By
this function, all the items in all of menus will collectively return to
the initial setting. Note that the items LAMP TIME, FILTER TIME,
LANGUAGE and SECURITY are not reset.
RESET  CANCEL
OPTION Menu (continued)
OPTION Menu
 (4106
 612
4'/16'4'%'+8
'06'4 
  4'#4
㪜㪥㪫㪜㪩
(continued on next page)
4'/16'(4'3
 014/#.
 *+)*
'06'4 㪜㪥㪫㪜㪩