Hitachi DZMV580A - Manual (Page 44)

English
44
Inserting and Removing Disc
INSERTING DISC
1
Press down the DISC EJECT button once and
release it.
A few moments after the ACCESS/PC
indicator blinks, the cover of disc insertion
block will open slightly.
2
Gently open the cover by hand until it stops.
3
Insert the disc, in Round DVD Holder, into the
disc guide until it stops.
Note that the recording/playback surface of
disc must face the inside of DVD video camera/
recorder. The orientation for inserting the disc
into the disc guide is also predetermined: Load
the disc correctly, referring to the figure below.
• The disc exposed portion must face in the same
direction as the lens, as shown in figure.
• The recording/playback side must face the inside
(DVD video camera/recorder).
4
Push the section marked “PUSH CLOSE” on
the cover of disc insertion block, to close the
cover.
5
Turn the DVD video camera/recorder on
(O VIDEO or N PHOTO).
When “DISC ACCESS” disappears, the DVD
video camera/recorder is ready for recording.
● Identifying recording/playback
sides of disc:
Single sided disc:
The recording/playback side
is opposite to the printed
label.
Double-sided disc:
The recording/playback side
of “SIDE A” is opposite to the
“SIDE A” marked side.
The recording/playback side
of “SIDE B” is the “SIDE A”
marked side.
Disc cover
DISC EJECT
button
PUSH CLOSE
portion
Disc
guide
Correct
orientation Incorrect
orientation
Incorrect orientation
“SIDE A” mark
The opposite side is
the “SIDE A”
recording/playback
side.