Hitachi DZMV580A - Manual (Page 46)

English
46
REMOVING DISC
1
Set the power switch to
“POWER OFF” to turn the
DVD video camera/
recorder off.
2
Press down the DISC EJECT
button once and release it.
In a moment, the cover of
disc insertion block will
open slightly.
3
Gently open the cover until
it stops.
When the cover is fully
open, the disc will slightly
come out from the disc
guide, and stop.
4
Remove the disc.
Hold the top of Round
DVD Holder as shown in
the illustration and
gently pull it out.
Note
:
Be careful not to touch the
disc exposed portion when
removing the disc.
5
Gently push the section
indicated “PUSH CLOSE”
on the cover of disc
insertion block, to close the
cover.
Note :
• Even after the DVD video camera/recorder is turned on,
the disc can be removed unless it is in recording status.
Hold down the DISC EJECT button for approximately 2
seconds, and then release it to remove the disc. (The
DISC EJECT indicator on the LCD screen will blink.) It is
recommended that you turn the DVD video camera/
recorder off before inserting or removing disc to prevent
misoperation.
• Do not remove the battery or disconnect the AC adapter/
charger during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery or AC
adapter/charger, push down the DISC EJECT button
once, and then release it.
• Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
• Set the power switch to “POWER OFF” to turn the DVD
video camera/recorder off.
• When inserting or removing the disc, be careful not to
touch the inside of DVD video camera/recorder
(especially, the lens of laser pickup (see “Terminology”,
P. 160)). Also, BE SURE NOT to look into the lens in laser
pickup: Doing so could damage your eyesight.
DISC EJECT
When grasping the
holder, avoid the disc
exposed portion.