HP 1100dtn - Manual (Page 68)

4-18 ENWW
Placement of the text or graphics is wrong
Check the page-orientation setting
z The page orientation selected might not be correct for the document you are printing.
Make sure the media size and page orientation selected in the application match the
settings in the Print Settings dialog box. See
“Changing printer settings” .
Check the paper size
z The Paper Size setting might not match the size of media you are using. Select the
correct paper size from the printer driver.
z Some of the content might be missing or cut off if the document size is larger than the
media loaded in the tray.
If the layout of the document you are trying to print will fit on a media size supported by the
printer, then load the correct media size. Make sure to select the correct page orientation.
Alternatively, select Emulate LaserJet Margins in the printer driver to scale the
document to fit the media size currently selected.
Check the margin settings
z If the text or graphics are cut off at the edges of the page, make sure that the margin
settings for the document do not exceed the printable area of your printer. See
“Setting
minimum margins” .
Check how the media is loaded
z Make sure that the width and length guides fit snugly against the left and bottom edges of
the stack of media. For Tray 1, make sure that the tray is contains no more than 150
sheets of media or a stack no thicker than 0.58 inch (15 mm). For Tray 2, make sure it
contains no more than 250 sheets or media or a stack no thicker than 0.98 inch (25 mm).
See
“Loading media” .
If none of the above solutions worked, the problem is likely caused by the inability of the
application to interpret print settings properly. Check the release notes for known software
conflicts. Otherwise, check your application manual, or call the software manufacturer for
more specific help for this problem.