HP TM 11-6625-2779-14&P - Manual (Page 12)

Section II Model 355B
2-12. INSTALLATION AND REMOVAL OF
BATTERY.
2-13. To install or replace a battery, turn the four 1/4
turn fasteners on the battery cover on the rear of the
case counterclockwise to remove the cover. Lift off the
cover, lift the battery out of its recess and unplug the
three-prong connector.
2-14. Reverse the above procedure when installing a
new battery.
2-15. COVER REMOVAL.
2-16. To remove the cover from the instrument,
release the two spring latches on either side of the
instrument, then lift cover. When replacing the cover,
first check the latches for released position; then place
cover in position for latching. The power cord is stored
inside the cover by wrapping it around the retainer
fastened inside the cover.
CAUTION
DO NOT FORCE COVER INTO
PLACE. THERE IS A PROJECTION
ON THE COVER WHICH TURNS THE
POWER SWITCH TO THE OFF
POSITION TO PRESERVE BATTERY
LIFE. IF THIS IS NOT BINDING, THE
COVER FITS EASILY INTO PLACE.
2-17. REPACKAGING FOR SHIPMENT.
2-18. The following is a general guide for repackaging
at instrument for shipment. If you have any questions,
contact your local Sales and Service Office. (See
Appendix for locations.)
a. Place instrument in original container if
available. If not available, one can be
purchased from your nearest -hp- Sales
and Service Office.
b. Wrap instrument in heavy paper or plastic
before placing in inner container.
c. Use plenty of packing material around all
sides of instrument.
d. Use a heavy carton or wooden box to
house the instrument and inner container
and use strong tape or metal bands to seal
the shipping container.
e. Mark shipping container with "Delicate
Instrument" or "Fragile".
2-2