Hotpoint RF725GP - Manual (Page 26)

the
(continued)
How to Delay Start
of Cleaning
Start is setting the oven
to start clean cycle
at time than
present time day.
beginning make
the oven shows the
correct time day.
Quick Reminder—Delay Start
for Self-Clean:
1. Prepare oven cleaning.
2. Press CLEAN pad.
3. Press INCREASE pad.
4. Press STOP TIME pad.
Time that appears is 3 hours
than the time day. Press
INCREASE until the Stop
Time you desire appears in
the display. The self-clean
will automatically begin
hours before the stop time
you select.
For example: Let’s say it’s
and you want the oven to begin
self-cleaning
after you’re
Step 4: Press INCREASE pad.
Three hours cleaning time is
automatically set.
Step 5: If a longer or shorter Clean
Time is desired, press INCREASE
or DECREASE pad until desired
Clean Time is displayed.
Step 6: Press STOP TIME pad.
appears on display and
“STOP TIME” flashes. The control
automatically sets Stop Time by
adding the Clean Time to the time
of day. In this example, the time of
day is
and the Clean Time is 3
hours. Adding 3 hours to the time
of day equals
finished in the kitchen. oven is
just soiled normal amount so the
normal Time of 3 hours
A
is preferred.
Step 1: Prepare the oven
cleaning. 7: Time from
Step 2: Close the oven door. Make
to by
INCREASE pad until “
sure the oven light is off.
appears in the display. The words
“DELAY CLEAN” will also
appear in the display.
The self-clean cycle will
automatically begin at
and
finish at The word “ ON ”
will appear on the display
When the oven to high
temperature, the word “LOCK”
will be displayed. It will not be
possible to open the oven door
until the temperature drops below
the lock temperature.
When the clean cycle is finished,
the word “CLEAN” will go out in
the display and the oven will begin
to cool. When the oven
temperature has fallen below the
locking temperature (about 20-30”
minutes after the word “CLEAN”
goes out the end of the
cycle), the word “LOCK” goes out
and the door can be opened.
Step 8: When the LOCK light is
off open the door.
After a Clean Cycle
After a clean cycle, you may
notice some white ash in the
Just wipe it up with a damp cloth.
If white spots remain, remove
them with soap-filled steel wool
pad. Be sure to rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the
cycle.
If the oven is not clean after one
clean cycle, the cycle may
be repeated.
Step 3: Press CLEAN pad.
26