Husqvarna 16 - Manual (Page 15)

English –
13
PRESENTATION
Cutting unit
The Rider 16 can be fitted with four different cutting
units.
Rear ejector - 970 mm/38"
Side ejector - 970 mm/38"
BioClip
- 900 mm/36", 1030 mm/41"
Combi - 1120 mm/44"
See ”Maintenance \ Checking the Blades” for
identification of the cutting unit.
Lifting of the cutting unit (transport position)
Lowering of the cutting unit (cutting position)
Lift lever for cutting unit
The lift lever is used to set the cutting unit in trans-
port or cutting position.
If the lever is pulled back the unit will lift up and the
blades will automatically stop rotating (transport
position).
If the lock button is pressed and the lever is moved
forward the unit will be lowered and the blades will
automatically start rotating (cutting position).
The lever can also be used to temporarily regulate
the cutting height, e.g. for a small mound in the
lawn.
6017-214
6004-011H
6004-012H