Husqvarna 16 - Manual (Page 20)

18
– English
Mowing pattern
DRIVING
4. Push in the lock button on the lift lever and
lower down the cutting unit.
WARNING!
Clear the lawn from stones and
other object which can be thrown
out by the blades.
Cutting tips
• Localise and mark stones and other fixed
objects to avoid collision.
• Start with a high cutting height and reduce down
until the required cutting result are obtained.
• The cutting results are best with a high engine
speed (fast rotating blades) and low driving
speed (slow moving machine). If the grass is not
too high and thick, the driving speed can be
increased without noticeably depreciating the
mowing result.
• The best lawns are achieved if the grass is cut
often. Mowing becomes more uniform and the
grass cuttings become more evenly distributed
over the surface. The total time consumption is
not greater since it is possible to select a higher
driving speed without inferior mowing results.
• Avoid mowing a wet lawn. The mowing results
are inferior since the wheels sink down into the
soft lawn.
• Wash down the underside of the cutting unit with
water after use. Do not use a high pressure jet.
Put the cutting unit in the service position while
doing this.
• If you use the BioClip unit it is important to mow
the grass regularly.
IMPORTANT INFORMATION
The service-life of the drive belts
increases considerably if the engine is
run at low speed when engaging the
blades. For this reason do not increase
the throttle until the cutting unit has been
lowered to the cutting position.
6007-212
6007-009H