Heat & Glo Fireplace HEAT&GLO ST-36TRB-IPI - Manual (Page 61)

Heat & Glo • ST-36TRB-IPI, PIER-36TRB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI • 2128-900 Rev. i • 3/13 61
F. Install the Log Assembly
Figure 2. Factory Installed Logs Figure 2. Factory Installed Logs F Figure 1. Log Assembly Location igure 1. Log Assembly Location
CAUTION: DO NOT reposition logs that have been
factory installed! Follow these instructions to position
the logs that were packaged separately.
1 1 2 2
3 3
A A
D D
B B
C C
2128-935
PILOT PILOT
STEP 1. CAUTION! Logs are fragile! Carefully remove the logs and cardboard tray from the inside of the fi replace.
See Figure 1. Remove the microfoam and inspect the logs for damage. Inspect the four factory installed logs for damage.
Locate the pilot in order to verify your position in relation to the appliance. See Figure 2.
STEP 2. Log #1 (SRV2128-704): Mate the notch on the end of log # 1 with the hump on top of log A. Set the other
end of Log #1 onto the smooth area on top of Log C.
Figure 4. Placement of Log #1 Figure 4. Placement of Log #1 F Figure 3. Placement of Log #1 igure 3. Placement of Log #1
1 1
1 1
A A
NOTCH NOTCH
HUMP HUMP
C C
Log Set Assembly: LOGS-2128
Models: ST-36TRB-IPI, PIER-36TRB-IPI
ST-36TVB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI