Henny Penny BFR/BCR-350 - Manual (Page 7)

Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350
2-1. INTRODUCTION This section provides the installation for the Henny Penny
blast chiller.
Installation of this unit should be performed only by a
qualified service technician.
Do not puncture the unit with any objects such as
drills or screws, or component damage or electrical
shock could result.
2-2. UNPACKING The Henny Penny blast chiller has been tested, inspected, and
expertly packed to ensure arrival at its destination in the best pos-
sible condition. The cabinet rests on a wooden skid and is then
packed inside a wooden box with sufficient padding to withstand
normal shipping treatment.
To avoid damage to the components, do not lay a unit
on its side if it has a compressor. If the unit has been on
its side, the unit must be in an upright position for at least
an hour before power is applied to the unit.
Check all components for signs of being loose or dam-
aged, and make sure the system has refrigerant.
Any shipping damage should be noted in the presence of
the delivery agent and signed prior to his or her departure.
To remove the Henny Penny blast chiller from the box, you
should:
1. Carefully cut banding straps.
2. Remove box from around unit.
3. Lift the unit off the skid.
503 2-1
SECTION 2. INSTALLATION