Harbor Freight Tools Windsor Design 60" Workbench 69054 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. Item 69054
3. Once both Legs have been fastened to the Cross Brace,
slide the Shelf (2) above against the Legs so that the far
edge fits onto the groove on the Cross Brace.
See Figure C, right.
4. While your assistant is holding the Shelf in place against the
first Cross Brace, set the second Cross Brace against the
other edge of the Shelf. See Figure D, right.
5. Once the Cross Brace is in place and the mounting holes on
the Legs are aligned with the Connecting Nuts in the Cross
Brace, use the Hex Wrench and Bolts to fasten the second
Cross Brace to Legs.
With your assistant’s help, place the Table Top (1) face down
on a smooth, padded surface. This will allow you to install
the sliding drawers.
note: When setting down the assembled Legs onto the Table
Top, verify both Legs and Table Top are facing the correct
direction. (Note the small “Front” labels placed on the items.
These labels can be removed after assembly.)
See Figure E, right.
Cross
Brace (3)
Leg (4)
Shelf (2)
Figure C
Figure 4
Shelf (2)
Cross
Brace (3)
Figure D
Figure e
Leg (4)
Table Top (1)
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup