Harbor Freight Tools Windsor Design 60" Workbench 69054 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. Item 69054
6. Set the Sliding Partition (14) into place by inserting the tabs at the end of the Partition into the holes at the center
of the Table Top’s underside. See Figure F, right.
note: Verify that the Sliding Partition and Table Top face the
same direction. See Figure G, right.
7. Use the Screws (13) to fasten the Sliding Partition to the
middle of the Table Top’s underside. See Figure H, right.
note: There are no pilot holes available for this step, so you will
need to use a drill to make the pilot holes before threading
in Screws.
8. Using assistance, set the assembled Legs and
Shelf onto the underside of the Table Top.
note: Verify that the Drawer guide slots on the Sliding Partition face
the same way as the Drawer guide slots on the Legs.
Figure F
Sliding
Partition (14)
Table
Top (1)
Figure G
Sliding Partition (14)
Table
Top (1)
Figure h
Sliding
Partition (14)
Table
Top (1)
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup