Hobart Welding Products BETASTICK 500 - Manual (Page 17)

OM-201 444 Page 13
3-3. Volt-Ampere Curves
Volt-ampere curves show mini-
mum and maximum voltage and
amperage output capabilities of
unit. Curves of other settings fall be-
tween curves shown.
va_curve1 – 4/95 – 201 172
3-4. Selecting A Location
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3 Plate Label
4 Rating Label
Use rating label to determine input
power needs. Label located on rear
access door (see Section 2-5).
5 Line Disconnect Device
Locate unit near correct input pow-
er supply.
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20. 5
18 in
(460 mm)
18 in
(460 mm)
OR
1
2
Movement
Location And Airflow
3
4
Ref. ST-800 402-A / ST-139 445-C