Husqvarna Viking CA 150 - Manual (Page 10)

10 – English
MAINTENANCE
Bevel gear
The bevel gear is filled with the right quantity of grease at the
factory. However, before using the machine you should check
that the bevel gear is filled three-quarters (40g) full with
grease. Use HUSQVARNA special grease.
CAUTION! The gear housing must not be filled completely
with grease. The grease expands as the machine heats up
during operation. If the gear housing was completely filled
with grease it could damage the seals and lead to leakage of
grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
Replacing the tine
Loosen the split pin and cotter pin.
Remove the tine unit from the angle gear’s output axle.
Loosen the 3 screws holding the tine.
Replace the tine with a new and assemble in the reverse
order.
Maintenance schedule
Below you will find some general maintenance instructions. If
you need further information please contact your service
workshop.
Daily maintenance
1 Check that the guard is undamaged and not cracked.
Replace the guard if it has been exposed to impact or is
cracked.
2 Check that the blades do not move when the engine is
idling or when the choke is in the start throttle position.
3 Check that the tines are undamaged and show no signs of
cracking or other damage. Replace the tines if necessary.
Weekly maintenance
1 Check that the bevel gear is filled three-quarters (40g) full
with lubricant. Fill if necessary using special grease.
1 2 3
1