Husqvarna Viking CA 150 - Manual (Page 8)

8 – English
ASSEMBLY
Fitting the bevel gear
• Assembling the angle gear on the shaft. Turn the shaft so
that the splines on the drive axle mate in the angle gear.
• First tighten the screw H and then the screw M.
Assembling the guard.
• Remove the four screws C and the two screws F from the
bracket A.
• Place the rubber sleeve D on the shaft E. The rubber
sleeve should sit between the arrow markings on the
shaft.
• Place the bracket A around the rubber sleeve and fit the
screws F loosely.
• Guide the guard B onto the shaft so that the hole in the
guard aligns with the hole in the bracket. Tighten the
screws C.
• Align the bracket with guard so that it sits straight in
relation to the tines.
• Tighten the screws F.
M
H
F
A
C
D
E
F
A
A
4 x C
B