Hitachi HCX5000I - Manual (Page 51)

H OLDING A S INGLE C ALL S ELEC S ET 500A U SER G UIDE
1-40 HCXTD840, Issue 1, July 2001
One active call
and two calls
held This display indicates one active call and two calls being
held using hold loop keys:
Using the hold
key Use the hold key to hold a call as follows:
1 Press the <HOLD> key while on an active call.
A CAP winks representing the held call.
2 Press the winking CAP to retrieve the call.
Using the <HOLD> key ties up a CAP (at least two
CAPs must be available before a call can be
answered. This ensures that one CAP can be used to
answer a call, while another can be used to place a
call.) Therefore, if your console is programmed with
hold loops, use a hold loop rather than the hold key to
hold a single call. The hold loops are preferred
because they do not tie up CAPs.
Placing a
conference call
on hold To place a conference call on hold, you must use the
<HOLD> key. Neither hold loops nor soft park can be
used to hold conference calls.
1 1 : 0 0 a m We d Ma r 1 0 6 8 6 C a l l s Wa i t : 0
1 * C o n n e c t 9 1 1 6 8 8 2 0
2
3
4
L 1 2 0 1 S t a t i o n L 2 1 3 3 S t a t i o n
L 3 L 4
MS G C H A R GE F E A T U R