HONDA 2008 Fit - Manual (Page 200)

Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Make sure that the hold-down
wire is installed properly and
securely. You can check its
installation from the inspection
window on the headlight assembly.
Install the rubber seal over the
back of the headlight assembly.
Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
5.
6.
3.
4.
7.
8.
CONTINUED
Lights
Ma
int
e
na
nce
197
RUBBER WEATHER SEAL
HOLD-DOWN
WIRE
BULB
ELECTRICAL
CONNECTOR HOLD-DOWN
WIRE
INSPECTION WINDOW
2008 Fit
Table Of Contents Main Menu