HONDA 2008 Fit - Manual (Page 201)

Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, then pull the inner
fender cover back.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
Reinstall the inner fender cover.
Then reinstall the holding clip, and
lock it in place by pushing on its
center.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
1.
2.
9.
10.
Lights
Replacing a Parking Light/Front
Side Marker Bulb and a Turn
Signal Light Bulb
198
HOLDING CLIP
2008 Fit
Table Of Contents Main Menu