Document Outline

• Introduction and Safety
  • Safety
    • Safety message levels
    • Environmental safety
    • User health and safety
      • Precautions before work
      • Precautions during work
      • Clean chemicals from the eyes
      • Clean chemicals from the body
    • Safety regulations for Ex-approved products in potentially explosive atmospheres
  • Product warranty
• Transportation and Storage
  • Receive the unit
  • Unpack the unit
  • Pump handling
    • Lifting methods
  • Pump storage requirements
    • Prepare the pump for long-term storage
• Product Description
  • General description
  • Nameplate information
• Installation
  • Preinstallation
    • Inspect the barrel flange or sub-base
    • Concrete foundation requirements
      • Install the barrel or sub-base on a concrete foundation
      • Grout the barrel or sub-base
    • Install the pump on a structural-steel foundation
    • Piping checklists
      • General piping checklist
      • Suction and discharge piping checklist
  • Install a partially-assembled pump
  • Install the bowl assembly
  • Install the threaded coupling
  • Install the column
  • Install the discharge head
  • Stuffing box installation
    • Install the type A and B stuffing boxes
    • Install the type C stuffing box
  • Mechanical seal options
    • Install the mechanical seal
    • Assemble a single inside-mounted mechanical seal
    • Assemble a single outside-mounted mechanical seal
    • Install the high-pressure seal
    • Install the dual mechanical seals
  • Install a solid-shaft driver
    • Install the coupling hub
    • Impeller adjustment
    • Adjust the impeller for a solid-shaft driver
  • Install a hollow-shaft driver
    • Assemble the type AR rigid-flanged coupling
    • Complete the hollow-shaft driver installation
    • Adjust the impeller for a hollow-shaft driver
  • Installation and startup checklist
• Commissioning, Startup, Operation, and Shutdown
  • Preparation for startup
    • Prepare for startup
  • Pump priming
  • Start the pump
  • Pump operation precautions
  • Mechanical seal leaks
  • Stuffing box leaks
  • Shut down the pump
  • Lubricate the thrust pot during a shutdown period
• Maintenance
  • Maintenance schedule
  • Packing adjustment and replacement
    • Adjust the packing when leaking is excessive
    • Adjust the packing when there is overheating or no leaks
  • Thrust pot lubrication guidelines
  • Disassembly
    • Disassembly precautions
    • Disassemble the head and column
    • Bowl disassembly
      • Disassemble the taper collet bowl
      • Disassemble the keyed bowl
    • Remove the turbine bowl and impeller wear rings
    • Remove the bowl, suction bell, and lineshaft bearings
  • Pre-assembly inspections
    • Replacement guidelines
  • Reassembly
    • Install the turbine bowl and impeller wear ring
    • Install the bowl, suction bell, and lineshaft bearings
    • Install the taper collet bowl assembly
    • Install the keyed bowl assembly
    • Pump shaft setup dimensions
• Troubleshooting
  • Operation troubleshooting
• Parts Listings and Cross-Sectional Drawings
  • VIC-T
  • VIC-L
• Local ITT Contacts
  • Regional offices