HP 16500C Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 16500C HP
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 130 |
| Size: | 711 KB |
Show table of contents
Read manual
Document Outline
- HP 16500C—At a Glance
- In This Book
- Contents
- Triggering
- To store and time the execution of a subroutine
- To trigger on the nth iteration of a loop
- To trigger on the nth recursive call of a recursive function
- To trigger on entry to a function
- To capture a write of known bad data to a particular variable
- To trigger on a loop that occasionally runs too long
- To verify that all stacks and registers are restored correctly before exiting a subroutine
- To trigger after all status bus lines finish transitioning
- To find the nth assertion of a chip select line
- To verify that the chip select line of a memory chip is strobed after the address is stable
- To trigger when expected data does not appear on the data bus from a remote device when requested
- To test minimum and maximum pulse limits
- To detect a handshake violation
- To detect bus contention
- Cross-Arming Trigger Examples
- Intermodule Measurements
- Intermodule Measurement Examples
- To set up a group run of modules within the HP 16500C
- To start a group run of modules from an external trigger source
- To start an external instrument on command from a module within the HP 16500 and 16501 mainframe
- To see the status of a module within an intermodule measurement
- To see time correlation of each module within an intermodule measurement
- To use a timing analyzer to detect a glitch
- To capture the waveform of a glitch
- To capture state flow showing how your target system processes an interrupt
- To test a circuit using stimulus-response
- To use a state analyzer to trigger timing analysis of a count-down on a set of data lines
- To monitor the activity of two coprocessors in a target system
- Special displays
- Skew Adjustment
- Intermodule Measurement Examples
- File Management
- Concepts
- If You Have a Problem
- Analyzer Problems
- Preprocessor Problems
- Inverse Assembler Problems
- Intermodule Measurement Problems
- Messages
- “Default Calibration Factors Loaded” (HP 16540, 16541, and 16542)
- “. . . Inverse Assembler Not Found”
- “Measurement Initialization Error”
- “No Configuration File Loaded”
- “Selected File is Incompatible”
- “Slow or Missing Clock”
- “State Clock Violates Overdrive Specification”
- “Time from Arm Greater Than 41.93 ms”
- “Waiting for Trigger”
- Application Notes
- Glossary
- Index