Document Outline

• RQT4220-1P
• ■ filili ttttllitlfell
  • 3.
  • 4.
  • 3
  • Nacement of cetiter/suir^ml speakers |
    • For your reference
    • Caution
    • Ions
    • n Connect the FM indoor antenna.
    • Connect the AM loop antenna.
    • Q Connect the front speakers.
      • When speakers are connected to the low and high terminals on the back of the main unit
      • Caution
    • Connect the center speaker.
    • Connect the surround speakers.
    • Q Connect the AC power cord.
• i
  • Turning the demo function ON/OFF
  • Q Switch on the power.
  • Q Press CLOCKn'flVIER to select “CLOCK”.
    • (within 7 seconds or so)
  • Press V or A to show the present time.
  • Press CLOCK/TilWER to finish setting the time.
    • To display the time when power is ON
• i
  • s
    • Press TUNER BAND to select the band.
    • n Press TUNE MODE to select “MANUAL”.
    • Press V or A until the display shows the frequency from which you want to begin automatic memory presetting.
    • Fj Press and hold MEMORY until the frequency begins to change.
      • If auto presetting is not possible because radio signals are weak or for some other reason, do the following.
      • Preset the stations one at a time.
      • Memory retention
      • FM allocation settings:
    • n Pt'ess TUNER BAND to select band.
    • n Press TUNE MODE to select “PRESET” or “MANUAL”.
    • B Press V or A to select the desired broadcast.
    • Adjust the volume level.
      • Hold down either v or a, and release the button when the frequency starts scrolling.
      • To stop auto tuning
  • s
    • §■
    • 8
      • Set CDs in the rack,
      • Q Press DISC/TRACK to select the CD selection mode.
      • PI Turn JOG to select the desired CD number.
      • Pj Adjust the volume level.
        • To stop the CD play
        • When “ ^ ” appears on the display 0
        • C
  • g
    • &
      • Q
      • Q Press DISC/TRACK to select the CD selection mode.
      • 0 Turn JOG to select the desired CD number.
      • Press DISC/TRACK to select the track selection mode.
      • Turn JOG to select the desired track number.
        • To select a two-digit track
        • For example
      • El
      • Press OPEN to open the rack panel, and set the CD in slot No. 0.
      • Close the rack panel and press SINGLE >,
        • To cancel repeat play
        • To repeat your favorite tracks
        • To repeat just one track
        • To repeat afl tracks on a specific CD
        • To cancel random play
        • For random play with just one specific CD
  • 8
  • □
    • o o
    • o o
    • o o
    • o
    • o o
      • 0.0
    • o o
    • o
    • o o
  • □
    • n Press CD.
    • Press PROGRAM.
    • Press DISC.
    • Select the CD(s) you want with the numeric button(s).
    • Press the numeric button(s) to select the desired track.
    • Repeat steps 3 through 5 until you have programmed ail the tracks you want.
    • Press PROGRAM.
      • i
    • о О О
      • To cancel program play mode Press PROGRAM in the stop mode.
      • To select a two-digit track
      • For example
      • When “CD FULL” appears H
      • You can do the following while stopped during program mode
      • Memory retention
      • C
    • s
      • &
      • 8
        • To replay your program
        • If you program a track not on your CDs
        • Press CD,
        • Q Press CD MANAGER to select the desired mode.
        • Ql Press DISC/TRACK to select the CD selection mode.
        • pj Turn JOG to select the desired CD number.
        • Q Press DISC/TRACK to select the track selection mode.
        • Turn JOG to select the desired track number.
        • Press /11/A.
          • To stop play
          • When playback ends
        • Press TEXT MODE.
          • In the stop mode H
          • In the play mode B
• i
  • 6
  • 8
    • Press DISC/TRACK to select the CD selection mode.
    • Q Press TEXT MODE to select "ALBUM”, and turn JOG to select the desired album title.
      • To playback the CD
      • C
  • 8
    • n Press DISC/TRACK to select the track selection mode.
    • Q Press TEXT MODE to select “SONG”, and turn JOG to select the desired song title.
      • To playback the song
    • CD-TEXT function
      • In the stop mode
      • Press DISC/TRACK to select the CD selection mode.
      • U\ Select the disc you want to name by turning JOG.
        • El While the CD number is fiashing (approx. 10 seconds) Press TEXTEDIT.
      • Turn JOG to select the first character.
• i
  • Press
  • 5
  • 6
    • Repeat steps 4 and 5 to enter characters.
  • 8
    • Press TEXT EDIT.
    • m
  • g
    • Types of tapes which can be played correctly:
    • Press DECK 1 A OPEN or DECK 2 A OPEN and insert the tape.
    • Press REV MODE to select the reverse mode.
    • Press ◄ or ► to start playback.
    • Adjust the volume level.
      • To stop tape playback
      • To change the deck to be used El
      • To listen to 2 tapes consecutively
    • 6
      • ■8
      • .§■
  • □
    • Press the SOUND EQ joystick to turn on the equalizer.
    • Dial SOUND EQ to select the sound quality or sound field.
      • When using the remote control to perform the operations described above
    • Press SUPER.WOOFER.
    • s
      • &
        • Press the SOUND EQ joystick to turn on the equalizer.
        • Dial SOUND EQ to display “Al EQ”.
        • operate the SOUND EQ joystick and set the sound quality as desired.
        • Press the SOUND EQ joystick to turn on the equalizer.
        • Dial SOUND EQ to display “MANUAL”.
        • Operate the SOUND EQ joystick and set the sound quality as desired.
      • &
        • 3
        • Q
        • 3
        • w»
    • s
      • 3
      • n Press DOLBY PRO LOGIC to turn on the DOLBY PRO LOGIC system.
      • Q Press CENTER MODE to select “NORMAL”.
      • Press TEST to output a test signal.
        • 3
  • B
    • Press VOLUME (—) or {+) to set the volume level normally used for enjoying the source.
    • Press CH SELECT to select the center or surround speakers.
    • Press CH LEVEL (—) or (+) to adjust the output level.
      • To stop the test signal
      • To turn off the DOLBY PRO LOGIC systems
    • Press DOLBY PRO LOGIC to turn on the DOLBY PRO LOGIC system.
    • Select and start the desired source.
      • To turn off the DOLBY PRO LOGIC systems
    • Disconnect the microphone(s).
    • Press TAPE.
    • Q Insert the recorded tape into deck 2.
    • Q Press REV MODE to select reverse mode.
    • B Press • REC/STOP.
    • n Press DECK 2 ^ OPEN and Insert the tape.
    • Press REV MODE to select the reverse mode.
    • Select a radio station.
    • PI Press • REC/STOP to start recording.
      • To stop recording
      • To start recording on the reverse side
      • To record from a specific point on a tape
      • To cut an unnecessary part whiie recording
      • Press FM iWODE/BP while recording.
      • C
    • s
      • &
  • 0
  • 0
    • i!
      • _ ____ V _ _.
        • Press DECK 2 ^ OPEN, and then insert the tape.
        • Press REV MODE to select the reverse mode.
        • Press CD.
        • Set CDs in the rack.
        • Press DISC/TRACK to select the CD selection mode.
        • Turn JOG to select the desired CD number.
        • Press # REC/STOP to start recording.
          • To stop recording
          • To start recording on the reverse side
          • To record from a specific point on a tape
  • □
  • □
    • Q
      • El
        • Before recording
        • Press CD.
        • Q Press CD MANAGER to select the desired
        • mode.
        • Q Press DISC/TRACK to select the CD selection
        • mode.
        • 3 Turn JOG to select the desired CD number.
        • Press DISC/TRACK to select the track selection mode.
        • B Turn JOG to select the desired track number.
        • Press • REC/STOP to start recording.
          • To stop recording
        • Press TAPE.
        • B Press ^ OPEN on both decks and insert the tapes.
        • PI Press REV 1VIODE to select the reverse mode.
        • □ Press TAPE EDIT to start recording.
          • To stop recording:
          • To start recording on the reverse side
          • To record from a specific point on a tape
          • by remote control only
          • C
      • vO
        • n First, lower volume with MIC VOL, connect the microphone(s).
        • Press KARAOKE to select the voice mode.
        • Start the source (CD, etc.).
        • y Adjust volume with VOLUME and MIC VOL and sing along.
        • fl First, lower volume with WlIC VOL then, connect the microphone(s).
        • Q Press DECK 2 ^ OPEN to insert the tape and then select the reverse mode.
        • Q Press KARAOKE to select the voice mode.
        • p] Start recording and KARAOKE performance.
          • Preparations
        • H Press CLOCK/TIMER to select ‘© PLAY”.
          • (Within 8 seconds or so)
        • © Press V or A to select the starting time. © Press CLOCK/TIMER.
        • © Press V or A to select the ending time. ©Press CLOCK/TIMER.
        • Select the desired source and then prepare for playing.
        • Set the playback volume, g Press © PLAY/© REC to select “® PLAY”.
        • (/slft0 file t/mer
        • H Press CLOCK/TIMER to select “© REC”.
          • (Within 8 seconds or so)
        • ® Press V or A to select the starting time. ® Press CLOCK/TIMER.
        • © Press V or A to select the ending time. (2) Press CLOCK/TIMER.
        • Select the desired source and then prepare for recording.
          • To record from the radio
        • B Prepare for recording.
        • g Press © PLAY/0 REC to select “© REC”.
          • To switch the timer OFF
          • if you set the timer incorrectly
          • To check settings
          • To enjoy a source after the timer setting is completed
          • Turning the timers ON/OFF
        • Press SLEEP to select the desired time.
          • To cancel the sleep timer:
          • w
        • a:
          • How to hold CDs
          • How to clean CDs
          • To re-record on a protected cassette
      • (^DS® (Sdí®
        • Handle CDs as shown on the left (E S)-
        • Do not place or store discs in the following places
        • Cassette tapes exceeding 100 minutes
        • Endless-tapes
        • To re-record on a protected cassette
        • Do not place or store tapes in the following places;
        • To clean this unit, wipe with a soft, dry cloth.