Document Outline

• FM Stereo FM-AM Receiver
  • WARNING
    • IMPORTANT
    • CAUTION
    • Note to CATV system installer
    • Owner's record
  • Precautions
    • On safety
    • On power sources
    • On placement
    • On operation
    • On cleaning
  • About This Manual
    • Conventions
    • Getting Started
    • Receiver Operations
    • Additional Information
    • Index 24
    • Rear Panel Descriptions 25
    • Remote Button Descriptions 26
    • Quick Reference Guide 27
  • Antenna Hookups
    • Overview
      • If you have poor AM reception
    • Connecting a ground wire
      • What antennas will I need?
    • Hookups
  • Audio Component Hookups
    • Overview
    • Hookups
      • CD player
  • Video Component Hookups
    • Overview
      • MD recorder or Tape deck
    • Hookups
      • White (L) Red (R)
      • White (L) Red (R)
      • Black <=CBC3=
      • Yellow =Catt=>=
      • =aE3= Yellow
      • 'Q' You can play decoded Dolby Digital AC-3 soundtracks through the speakers connected to the amplifier.
  • Speaker System Hookups
    • Overview
      • 45°
      • What cords will I need?
      • To avoid short-circuiting the speakers
        • Stripped.cords are touching each other due to excessive removal of insulation
    • Selecting the speaker system
      • Note
  • AC Hookups
    • Connecting the AC power cord
      • SWITCHED AC OUTLET
  • Before You Use Your Receiver
  • Selecting a Component
    • Watching/listening to video programs
    • Using the remote
      • SYSTEM
      • STANDBY
    • Changing the factory setting of a function button
  • Receiving Broadcasts
    • Example 2: AM 1350 kHz
    • To receive other stations
    • If the STEREO indicator remains off
    • y If an FM stereo program is distorted
    • 'y If you cannot tune in a station and the entered numbers are flashing
    • y To watch FM simulcast TV programs
    • 'y If you enter a frequency not covered by the tuning interval
    • Receiving broadcasts by scanning stations (automatic tuning)
  • Presetting Radio Stations
    • DISPLAY
    • If “MEMORY" disappears, start again from step 3.
    • To change a preset station
    • Note
    • Tuning preset stations (preset tuning)
      • You can tune by scanning the preset stations
    • Naming preset stations
      • If you make a mistake
  • Recording
    • Audio signal flow •-: Video signal flow
    • To display index names
    • Notes
    • Recording on a MiniDisc or audio tape
    • Recording on a video tape
      • 'Q' You can replace audio while editing a video tape
      • Note
  • Using the Sleep Timer
    • You can check the time remaining before the amplifier turns off
  • Choosing a Sound Field
    • When you use the remote
      • When selecting program source
      • PRO LOGIC* ^ C. STUDIO I ► HALL ^ V DOLBY —
      • When using 5.1 CH/DVD
      • C. STUDIO ^ V SURR
    • To turn off sound field
    • ' The receiver memorizes the last sound field selected for each program source (Sound Field Link)
    • You can find Dolby Surround-encoded software by looking at the packaging
    • Note
    • Adjusting the Effect Level (except PRO LOGIC)
      • 'Q' When you use the remote
        • L EFFECTS EFFECTS ^ 1
      • Note
  • Getting the Most Out of Dolby Pro Logic Surround Sound
    • SOUND FIELD SOUND FIELD
    • Selecting the center mode
      • You can adjust all speakers at one time
    • Adjusting the speaker volume
      • V' You can also adjust the volume level with the controls on the receiver
      • ■Q' You can increase the output level of the rear speakers
    • Adjusting the delay time
      • Note
    • Adjustable parameters for each sound field when selecting programme source
      • Note
  • Troubleshooting
    • There's no sound or only a very low-level sound is heard.
    • The left and right sounds are unbalanced or reversed.
    • Severe hum or noise is heard.
    • No sound is heard from the center speaker.
    • Radio stations cannot be tuned in.
    • Surround effect cannot be obtained.
    • No picture or an unclear picture is seen on the TV screen.
    • Recording cannot be made.
    • The remote does not function.
    • No sound or only a very low-level sound is heard from the rear speakers.
  • Specifications
    • Audio power specifications
    • Amplifier section
    • FM tuner section
    • AM tuner section
  • Glossary
    • Center mode
    • • NORMAL mode
    • WIDE mode
    • PHANTOM mode
    • 3 STEREO mode
    • Surround sound
    • Delay time
    • Direct tuning
    • Dolby Pro Logic Surround
    • 5.1 CH/DVD
    • Preset station
    • • Transition of sound from rear speakers
    • Test tone
    • In a system without a center speaker (PHANTOM mode)
    • A. B
    • E, F,G
    • H, I, J, K, L, M
    • N, O
    • V
    • w. X. Y, Z
      • Note
  • Receiving Broadcasts Presetting Radio
  • Scanning Radio Receiving Preset
  • Using Pre-programmed Sound Fields
  • Scanning Preset Stations