Sony STR-DE335 User Manual
Fm stereo fm-am receiver
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Table of contents
Document Outline
- FM Stereo FM-AM Receiver
- WARNING
- Precautions
- About This Manual
- Antenna Hookups
- Audio Component Hookups
- Video Component Hookups
- Speaker System Hookups
- AC Hookups
- Before You Use Your Receiver
- Selecting a Component
- Receiving Broadcasts
- Example 2: AM 1350 kHz
- To receive other stations
- If the STEREO indicator remains off
- y If an FM stereo program is distorted
- 'y If you cannot tune in a station and the entered numbers are flashing
- y To watch FM simulcast TV programs
- 'y If you enter a frequency not covered by the tuning interval
- Receiving broadcasts by scanning stations (automatic tuning)
- Presetting Radio Stations
- Recording
- Using the Sleep Timer
- Choosing a Sound Field
- Getting the Most Out of Dolby Pro Logic Surround Sound
- Troubleshooting
- There's no sound or only a very low-level sound is heard.
- The left and right sounds are unbalanced or reversed.
- Severe hum or noise is heard.
- No sound is heard from the center speaker.
- Radio stations cannot be tuned in.
- Surround effect cannot be obtained.
- No picture or an unclear picture is seen on the TV screen.
- Recording cannot be made.
- The remote does not function.
- No sound or only a very low-level sound is heard from the rear speakers.
- Specifications
- Glossary
- Center mode
- • NORMAL mode
- WIDE mode
- PHANTOM mode
- 3 STEREO mode
- Surround sound
- Delay time
- Direct tuning
- Dolby Pro Logic Surround
- 5.1 CH/DVD
- Preset station
- • Transition of sound from rear speakers
- Test tone
- In a system without a center speaker (PHANTOM mode)
- A. B
- E, F,G
- H, I, J, K, L, M
- N, O
- V
- w. X. Y, Z
- Receiving Broadcasts Presetting Radio
- Scanning Radio Receiving Preset
- Using Pre-programmed Sound Fields
- Scanning Preset Stations