HP 2600/2700 - Manual (Page 211)

HP Quick Exchange Service (Japan)
HP Quick Exchange Service
0570-000511
:03-3335 -9800
: 9:00 5:00
10:00 5:00
1 1 3
:
Prepare your HP all-in-one for shipment
If after contacting HP Customer Support or returning to the point of purchase, you are requested to
send your HP all-in-one in for service, remove the print cartridges and pack the HP all-in-one in the
original packing materials to avoid further damage. You can remove print cartridges from your
HP all-in-one whether it is turning on or not. Retain the power cord and control panel overlay in
case the HP all-in-one needs to be replaced.
This section provides instructions on how to remove print cartridges from a functional HP all-in-
one, remove print cartridges from a non-functional HP all-in-one, and remove the control panel
overlay and pack your HP all-in-one.
Note This information does not apply to customers in Japan. For information on service options in
Japan, see
HP Quick Exchange Service (Japan) .
Remove print cartridges from a functional HP all-in-one
1 Turn on the HP all-in-one.
See
Remove print cartridges from a nonfunctional HP all-in-one if your device will not turn on.
2 Open the print-carriage access door.
3 Wait until the print carriage is idle and silent, and then remove the print cartridges from their
slots and lower the latches. For information on removing the print cartridges, see
Replace the
print cartridges .
Warning Remove both print cartridges and lower both latches. Failure to do so
might damage your HP all-in-one.
4 Place the print cartridges in print cartridge protectors or an airtight plastic container so they
will not dry out, and put them aside. Do not send them with the HP all-in-one unless the
HP customer support call agent instructs you to.
Chapter 17
208 HP Photosmart 2600/2700 series all-in-one
G
et HP
support