Hearth and Home Technologies Bravo - Manual (Page 36)

Hearth & Home Technologies • Bravo, Aztec • InD • 703-900 Rev. N • 8/06 36
Log Assembly: LOGS-AZTEC
E. Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
703-925
CAUTION: Logs are fragile! Carefully remove the logs
from the packaging. Before placing logs, remove shipping
bracket and tie straps from the burner and grate. Place the
lava rock on the bottom of the fi rebox. Evenly spread out
the lava rocks with your hand.
LOG #1 (SRV703-701):
Place log #1 between log tabs on the left side on the burner. The log should be pushed
forward until the groove in the log makes contact with the front log tab. The right side of the log should contact the fi rebox.
LOG #2 (SRV703-702):
Place log #2 fl ush with grate tines 3 and 4. On the front of log #2 there is a location feature
to help locate the log. Slide the log to the right until the location feature contacts the fourth grate tine.
1
1
2
2
BURNER
TAB
GRATE
3 4
1 2 3 4 5 6 7 8
3 4
Shipping Bracket
TIE STRAPS
Figure 12.2 Figure 12.3
Figure 12.4 Figure 12.5
Figure 12.6 Figure 12.7