Hearth and Home Technologies Bravo - Manual (Page 39)

Hearth & Home Technologies, Inc. • Bravo, Aztec • InD • 703-900 Rev. N • 8/06 39
Log Assembly: LOGS-BRAVO
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
704-936C
Figure 12.20
CAUTION: Logs are fragile! Care-
fully remove the logs from the
packaging.
Before placing logs, check that the
sensor on the pilot assembly does
not contact the burner.
Remove shipping bracket and tie
straps from the burner and grate.
Place the lava rock on the bottom of
the fi rebox. Evenly spread the lava
rocks with your hand.
LOG #1 (SRV750-703):
Place log #1 between log tabs on left side and right side of the burner. Place such that
bottom surface of log rests on burner surface (left).
1
2
4 5
3
6
GROOVE FOR
LOG #2
1
1
LEFT LOG
TAB
RIGHT LOG
TAB
BURNER
TAB
GRATE
Shipping Bracket
TIE STRAPS
SENSOR
ADJUST LOG SO
SURFACE IS FLUSH
Figure 12.20 Figure 12.20
Figure 12.20 Figure 12.20