Hitachi 32FX41B - Manual (Page 23)

USING THE REMOTE TO CONTROL VCR FUNCTIONS - 23 -
CAUTION: A pattern burn may develop if the sub-picture is left in the same corner
permanently. If the PIP feature is used frequently, occasionally shift the sub-picture to a different corner.
You may also vary its position using the CURSOR , , , or buttons.
USING THE REMOTE TO CONTROL VCR FUNCTIONS
CLU-432U Illustration CLU-431UI Illustration
Operating the pre-coded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the
remote system of your VCR. (Refer to page 34.)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the VCR button to switch to the VCR pre-coded mode.
4. Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR as
shown on page 34. The remote will turn off your VCR when the correct two digit preset code is entered.
When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after five
seconds, try a different two digit preset code.
5. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please
consult your VCR operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from
the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
5. The MENU button will act as the VCR MENU button for HITACHI VCRs.
6. The LST-CH button will act as your VCR ENTER button if required.
7. The SLEEP button will act as your VCR '100' button if required.
1 VCR Button
This button allows the remote to control your VCR by setting it to VCR mode.
2 PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD
button twice to record a program.
3 EXCLUSIVE TV buttons