Hitachi 32FX41B - Manual (Page 32)

SET UP - 32 -
Plug & Play Help Screens
Press CURSOR or to highlight the correct answers to both questions.
Press CURSOR to display the graphic guide.
Press EXIT to quit menu or CURSOR to begin AUTO CHANNEL SET. (See page 40.)
SIGNAL SOURCE
Select ANTENNA if you are using an indoor or outdoor antenna. Select CATV if you have cable TV.
Signal Source Screens
Press CURSOR or to highlight and select the correct SIGNAL SOURCE mode.
Press EXIT to quit MENU or CURSOR to return to previous menu.
Reception channels for each mode are shown at the left.
Refer to your cable or TV guide for channel identification standards.
If certain CATV channels are poor or not possible in CATV1 mode, set SIGNAL SOURCE to CATV2.
AUTO CHANNEL SET
This feature will automatically store active TV channels in CHANNEL MEMORY. This will allow you to
skip over unused channels when using the CHANNEL UP ( ) or DOWN ( ) buttons.
Auto Channel Set Screens
If the EXIT button is pressed while the AUTO CHANNEL SET function is engaged, programming will
stop. After AUTO CHANNEL SET press EXIT to quit or CURSOR to return to previous menu.If two
antennas are connected, switch antenna inputs with the INPUT button and repeat AUTO CHANNEL SET
for the second antenna input. Model 36CX35B does not have a second antenna (ANT B).
Remember to select the correct SIGNAL SOURCE mode before using AUTO CHANNEL SET for the
second antenna input.
See CHANNEL MEMORY to add or erase additional channels. (See page 41.)
CHANNEL MEMORY
Use this function after AUTO CHANNEL SET to add or erase additional channels to the remote control
CHANNEL or buttons.
Channel Memory Screens
Add or erase additional channels while still in CHANNEL MEMORY using CHANNEL or or the
number buttons to change the channel.