Hitachi 32FX41B - Manual (Page 24)

USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE
FUNCTIONS
- 24 -
These buttons are for operating the TV.
NOTE: Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.
USING THE REMOTE TO CONTROL CABLE BOX/SATELLITE FUNCTIONS
CLU-432U Illustration CLU-431UI Illustration
Operating the pre-coded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and satellite systems. You must first
program the remote to match the remote system in your cable/satellite box. (Refer to page 34.)
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. Press the CABLE button on the remote to switch to cable/satellite box mode.
4. Hold down the CABLE box button on the remote, enter the two digit preset code that matches your
cable/satellite box as shown on page 34. The remote will turn off your cable/satellite box when the correct
two digit preset code is entered. When this occurs, the remote control is programmed for your
cable/satellite box. If the cable/satellite box does not turn off after five seconds, try another two digit preset
code.
5. The remote will now control your cable/satellite box.
NOTES:
1. If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite
box code has not been precoded into the remote.
2. In the unlikely event that your cable/satellite box cannot be operated after performing the above
procedures, please consult your cable/satellite box operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from
the remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP
function.
5. The LST-CH button will act as the cable/satellite box ENTER button if required.
6. The SLEEP button will act as your cable/satellite box '100' button if required.
1 CABLE Button
This button allows the remote to control your cable/satellite box by setting it to cable/satellite mode.
2 PRECODED CABLE/SATELLITE BOX buttons
These buttons transmit the chosen precoded cable/satellite codes.
3 EXCLUSIVE TV buttons
These buttons are for operating the TV.
CABLE/SATELLITE, AND VCR CODES
CABLE BRAND CODES
ABC 00, 07, 08, 18, 19, 21, 37, 38, 53
Antronix 40
Archer
12, 25, 40
Belcor 33
Cable Star 33