Furuno GP-7000F - Manual (Page 58)

6. NAVIIGATION
6-4
6.2 Navigating to Waypoints
You can select an existing waypoint as destination by cursor, by name or
through the WAYPOINT LIST.
To cancel the navigation, locate the cursor on the destination waypoint, and then
press the STOP soft key.
Selecting waypoint by cursor
1. Press the cursor pad to place the cursor on the waypoint which you want to
set as destination.
2. Press the [TLL/GOTO] key.
A line runs between waypoint selected and own ship’s position. Also, range and
bearing from own ship’s position to waypoint appear in the data window.
Selecting waypoint by name
1. Press the cursor pad to place the cursor at a location not occupied by
waypoint.
2. Press the [TLL/GOTO] key to show the GOTO window.
CURSOR
POSITION
ROUTE
WAYPOINT
GOTO window
3. Rotate the [ENTER] knob to choose WAYPOINT and then push the [ENTER]
knob.
The SELECT NAME window appears.
0 0 0 1 WP
SELECT NAME
SELECT NAME window (for waypoints)
4. Enter the waypoint name you want to set as destination.
5. Press the SAVE soft key.
Selecting waypoint through WAYPOINT LIST
1. Press the [MENU] key to show the menu bar.
2. Rotate the [ENTER] knob to choose PLOTTER and then push the [ENTER]
knob.
3. Rotate the [ENTER] knob to choose WAYPOINTS and then push the
[ENTER] knob to show the WAYPOINT LIST.
4. Press the cursor pad (▲▼) to choose the waypoint which you want to set as
destination.
5. Press the [TLL/GOTO] key.