FRIGIDAIRE 318204125 - Manual (Page 2)

2
Setting the Clock
1 3 0
START
Clock
for 7 seconds
INSTRUCTIONS PRESS DISPLAY
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
START or Clear
/Off
Clear
/Off
TIMED
DOOR DELAY
LOCKED
TIMER
CLEAN
CONV
ROAST BAKE
WARM BROIL
PROBE
TIMED
DOOR DELAY
LOCKED
TIMER
CLEAN
CONV
ROAST BAKE
WARM BROIL
PROBE
TIMED
DOOR DELAY
LOCKED
TIMER
CLEAN
CONV
ROAST BAKE
WARM BROIL
PROBE
TIMED
DOOR DELAY
LOCKED
TIMER
CLEAN
CONV
ROAST BAKE
WARM BROIL
PROBE
The
Clock
pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Figure 1).
To set the clock (example below for 1:30)
1. Press
Clock
. "CLO" will appear in the display (Figure 2).
2. Press 1 3 0 pads to set the time of day to 1:30 (Figure 3).
"CLO" will stay in the display. Press START . "CLO" will disappear
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
Clock
for 7 seconds (Figure 3). After 7 seconds,
"12h" (Figure 5) or "24h" (Figure 6) will appear in the display and
the control will beep once.
2. Press
Clean
to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press START to accept the change or press Clear
/Off
Clear
/Off
to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Clean
Clock