FUJITSU CM71-00329-7E - Manual (Page 195)

185
CHAPTER2 Dependence Functions
■ Setting Measurement Unit
Either of the following methods can be used to set the measurement unit.
• Dialog
- Time Measurement Dialog
For details, refer to "4.6.8.1 Measurement Unit for Execution Time Measurement" of "SOFTUNE
Workbench Operation Manual".
• Command
- SET TIMERSCALE
For details, refer to "1.64 SET TIMERSCALE" of "SOFTUNE Workbench Command Reference
Manual".
■ Error Information
Click the [Comment] button in the time measurement dialog to display error information about the
measurement results.
Note:
The number of cycles measured normally includes an error of about 10 cycles. However, it may be
even more, depending on the bus state.
If a chip reset is issued during debugging, the measurement cycle count is cleared.