Furuno GPS NAVIGATOR GP-150 - Manual (Page 33)

5-1
5. STARTING FOR
DESTINATION
5.1 Setting Destination
There are four ways by which you can set
destination:
• By cursor
• By MOB position or event position
•
By waypoint, and
•
By route.
Note: Previous destination is cancelled
whenever a destination is set.
Setting destination by cursor
Using the cursor you may set a destination
consisting of 30 points. When all 30 points
are entered, the GP-150 automatically
disables further entry.
Setting single destination
1) Press the GOTO key. The menu shown in
Figure 5-2 appears.
2. MOB/Event Position
3. Waypoint List
4. Route List
5. Cancel
GOTO Setting
1. Cursor
ENT : Enter
: Cursor
MENU : Escape
Figure 5-2 GOTO setting menu
2) Press 1 to select Cursor. The display
shown in Figure 5-3 appears.
Place cursor on desired location
Press ENT twice to finish
ENT:Enter CLR:Clear MENU:Escape
Figure 5-3
If the display in use is Highway,
Navigation or Data display, the Plotter 2
display is automatically selected.
3) Place the cursor on the location desired
for destination.
4) Press the NU/CU ENT key.
Note: To clear selection, press the CLEAR
key.
5) Press the NU/CU ENT key to finish.
Control is returned to the display mode in
use before you set destination. A dashed
line connects own ship and the
destination, which is marked with a flag,
as shown in Figure 5-4.