Furuno GPS NAVIGATOR GP-150 - Manual (Page 34)

5. STARTING FOR DESTINATION
5-2
Flag
mark
Figure 5-4 Single destination set by cursor
Setting multiple destinations
1) Press GOTO and 1.
2) Place the cursor on the location desired
for waypoint.
3) Press the NU/CU ENT key.
4) Repeat steps 2 and 3 to enter other points.
Waypoints are connected with a line.
5) Press the NU/CU ENT key to finish. The
route number entry display appears as
shown in Figure 5-5. If no route number
appears or you want to change the route
number shown, go to step 6 to enter route
number. To register the route under the
number shown, go to step 8.
Enter route number
ENT:Enter MENU: Escape
0 1
Figure 5-5
6) Key in route number.
7) Press the NU/CU ENT key. Waypoints are
marked with flags and are connected with
a dashed line.
If the route number entered already exists
the message shown in Figure 5-6
appears.
Overwriting ?
ENT:Yes MENU:No
Figure 5-6
8) Press the NU/CU ENT key.
The waypoints do not have waypoint
numbers, however you can attach
waypoint numbers by doing the following.
1 Press WPT RTE and 6 to display the
route list.
2 Press or to select route number
entered.
3 Press .
4 Enter waypoint number, in three digits.
5 Press . If the waypoint number already
exists the message shown in Figure 5-7
appears.
This waypoint already exists
Are you sure to change ?
ENT:Yes MENU:No
Figure 5-7
6 Press the NU/CU ENT key. The waypoint
entered here replaces previously entered
waypoint.
Note: To cancel replacement of waypoint,
press the MENU ESC key at step 6.
7 Repeat steps 4 and 5 to enter other
waypoint numbers.
8 Press the MENU ESC key twice to finish.
When destination is cancelled, dashed lines
are erased but flags remain on the screen.