Furuno GPS NAVIGATOR GP-150 - Manual (Page 60)

8. MENU SETTINGS
8-12
5) Press or to select No. desired,
which has not been used.
6) Press or to show the Edit window.
Rate
Edit=DGPS Station: 18
MENU : Escape ENT : Enter
: Column
Position
200 bps
_ _ _ _’N _ _ _ _ _’W
FREQ _ _ _. _ kHz
: Cursor
Figure 8-28
7) Press or to select FREQ and then
enter frequency of the station, and then
press
. (Setting range: 283.5 to 320.5,
in 0.5 step)
8) Press or to select the baud rate,
100 or 200 bps, and then press .
9) Enter latitude and longitude of the station.
To change N to S or E to W, press .
Message “ARE YOU SURE?” appears.
10) Press the NU/CU ENT key.
The message “Please wait” appears, and
then the DGPS Station (User) list
appears.
Wrong frequency or position was entered
at step 7 to 9, the beep sounds and the
message “Incomplete Data” appears for
three seconds.
11) Press the MENU ESC key.
Editing DGPS stations
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
2) Press to select DGPS Station.
3) Press to select List to show the
Station Nearest list.
4) Press or to select User Setup,
and then press to go to the DGPS
Station (User) list.
5) Press or to select the station from
the list, and then press or to show
the Edit window.
Rate
Edit=DGPS Station: 17
MENU : Escape ENT : Enter
: Column
Position
200 bps
34 44’N 135 21’W
FREQ 3 20. 5 kHz
: Cursor
Figure 8-29
6) Edit data, and then press the NU/CU
ENT key.
7) After displaying the message “Are you
sure to change?”, press the NU/CU ENT
key. The DGPS Station (User) list
appears after the message “Please wait”.
8) Press the MENU/ESC key.
Erasing individual DGPS station
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
2) Press to select DGPS Station.
3) Press to select LIST to show the
Station Nearest list.
4) Press or to select User Setup,
and then press to go to the DGPS
Station (User) list.
5) Press or to select the station from
the list, and then press the CLEAR key.
The message “Are you sure to erase?”
appears.
6) Press the NU/CU ENT key. If cacelling,
press the MENU ESC key.
7) Press the MENU ESC key.
Setup for external DGPS beacon
receiver
When an external DGPS beacon receiver is
connected to the DATA 4 connector, set up
the GP-150 according to specification of
DPGS beacon receiver connected as
follows.
1) Press MENU ESC, 9 and 5.
2) Press or to select Level.
3) Press or to select level; RS232C
or RS422.