Yamaha CDX-497 - Manual (Page 13)

English
11
En
Normal illumination
Slightly dim
Dim
Notes
● When the automatic spacing function is in effect, the display of
the total time and of the total remaining time includes each
interval of the 4 seconds between tracks.
● When the automatic spacing function is in effect during the
playback, “AUTO SPC 4” (the remaining seconds of the
interval) appears and is counted down each time blinking at the
interval between the tracks.
When you listen with headphones, connect the headphones
to the PHONES jack.
You can change brightness of the display
in three degrees by pressing DIMMER.
Adjusting the output level (CDX-497 only)
You can adjust the level of signals output to the amplifier by
pressing OUTPUT LEVEL +/–.
If you record a disc onto tape with an insufficient time space between tracks, the tape deck will not be able to perform blank
search operations on the tape correctly. To enable a track search operation, use this function to add an interval of about 4
seconds between tracks.
Changing brightness of the display
DIMMER
SPACE
OUTPUT
LEVEL
Automatic spacing
Press SPACE to light up the current setting.
Light up about 3 seconds.
While the current setting is lit up, press SPACE to
change the setting between “AUTO SPACE ON” and
“AUTO SPACE OFF”.
Note
While playing back an MP3/WMA disc, the level of the audio
signal sent to the DIGITAL OUT (OPTICAL or COAXIAL)
terminal is fixed at maximum regardless of the displayed volume
level.
Note
When starting playback, be careful of the audio output level.
01_En_02_BOD_CDX-397_497_G.pm 11/1/06, 19:43 11