Yamaha CDX-497 - Manual (Page 20)

18
En
5
Use numeric buttons to select the track numbers (to
be recorded on the side B) in any order.
6
Press PROGRAM.
7
Start recording on the tape deck, and then press
on the remote control of this unit.
8
This unit automatically pauses at the end of the side
A. Turn the tape over to the side B, resume
recording on the tape deck, and then press
or
on the remote control of this unit to start
playback.
Manual tape-programming (for Audio CD)
1
Follow steps 1 – 3 on page 16.
2
Press PROGRAM.
3
Use numeric buttons to select desired tracks (to be
recorded on the side A) in any order.
* Programmed track numbers light up on the display.
4
When track selection for side A is finished, press
TAPE.
A pause is inserted.
SEARCH
SYNCHRO TAPE PEAK SPACE
REPEAT
DIMMER RANDOM
INDEX 0 9
6 5 8 7
2 1 4 3
A–B PROGRAM CLEAR
4
3, 5
2
SEARCH
TIME/INFO
FOLDER
SYNCHRO TAPE PEAK SPACE
REPEAT
DIMMER RANDOM
A–B PROGRAM CLEAR
7, 8
8
6
PROGRAM
0 9
6 5 8 7
2 1 4 3
0 9
6 5 8 7
2 1 4 3
PROG.
TAPE
PROG.
This is for recording desired tracks in any order onto a tape.
Notes
● If, in step 3 or 5, “Err” appears on the display, the track number
just selected cannot be programmed because there is not
enough time remaining on the tape.
● In step 3 or 5, each time a selection is made, the track number
and the remaining time of the tape is displayed, and then the
display changes to indicate the next program number.
● You can check, cancel or correct program data. (For details,
refer to page 15.)
* When checking program data, note that “Pu” appears
between track numbers for side A and side B.
● Up to 40 tracks can be programmed. If, however, a pause is
inserted, it is counted as one track.
● CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 7 and 8, press
SYNCHRO and then press
on the remote control of this
unit. Recording automatically starts. (For details, refer to page
21.)
Blinks.
01_En_02_BOD_CDX-397_497_G.pm 6/1/06, 8:37 PM 18