Meridian Audio 565 - Manual (Page 34)

Configuring the digital surround processor
30
● Use
A and V to choose between the following options:
Choose this For this type of speaker
Meridian A Meridian DSP Loudspeaker such as
the DSP5000, DSP5000C, DSP6000,
or DSP6000C connected to the
appropriate digital output.
Digital A digital signal for feeding a DAC
directly from the appropriate digital
output.
Analogue A power amplifier or active speaker
connected to the appropriate analogue
output.
To set the output delay
● Press
> or < until you see a
display such as:
1 Delay +0.0
● Using the diagram you completed at the start of this section,
calculate the correct delay as follows:
For measurements in inches: delay
furthest distance
=
-
12
For measurements in cm: delay
furthest distance
=
-
30
where distance is the distance to the speaker you are setting up,
and furthest is the distance to the furthest speaker.
For example, if the main left speaker is 120" (300cm) from the
listening position, and the furthest speaker is 180" (450cm)
away, set the delay for the main left speaker to +5.0.
Note that when you are setting up the furthest speaker its delay
should work out to be zero.
Repeat this for each of the speakers in your layout.