7 display functions 31, Display functions, 7display functions – Fluke 1522 User Manual

Page 32

Advertising
background image

7

Display Functions

The insturment operates in any of several modes which determine what infor-
mation is visible in the lower alphanumeric portion of the display. The MODE
button sequences through the menu functions. This button can be pressed re-
peatedly until a desired mode is set. The various modes are listed below in the
order they appear. Also refer to Figure 8.

Blank - No data shown

Min/Max - Display minimum and maximum measurements (CLR to re-
set)

Demand Logging - Store readings (up to 100) on demand in the memory
registers

Auto Logging - Store readings (up to 10,000) automatically in memory at
user selected intervals

Delta(x) - Display delta from reference measurement (ENT to set refer-
ence)

Units: C/

Ω/F/K/R - Set the units of measurement

Rate: 00000 - Set the period for serial transmission

Resol: XXX.XXX - Set the display resolution

CAL MODE - Set probe and instrument calibration parameters (MODE
button must be held for three seconds)

Note: Units, Rate, and Resol are temporary modes. The instrument returns to
Blank mode if left in any of these modes when the power is cycled.

31

7 Display Functions

Advertising