Frymaster D - Manual (Page 20)

DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-15
1.7.3 Replacing the Temperature Probe; Computer-equipped Fryers (cont.)
6. Remove the appropriate burners to gain
access to the temperature probe. (See Steps
20-22 on page 1-27 for more details.)
NOTE: Ensure that the burners are placed in their
original spots when putting them back into the
fryer. (See page 1-28.)
7. Loosen and unscrew the compression nut
and the pass-through nut completely from
the frypot. Proceed to the next step before
removing the probe from the frypot.
8. Remove temperature probe mounting
hardware. Some older pots may use a
spring-bracket combination. Newer pots use
mounting clips. Retain mounting hardware
for installation of new temperature probe.
Older pots have spring-bracket combinations.
Loosen and unscrew completely the compression
nut (bottom arrow), then the pass-through nut (top
arrow).
Newer pots have mounting clips.
Remove burners to gain access to temperature
probe.