Frymaster D - Manual (Page 28)

DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-23
1.7.8 Replacing the Frypot (cont.)
10. Remove screws securing flue-cap braces to frypot
(a nut-driver with an extension or long
screwdriver is required). Use care not to drop the
screws into the flues. If this happens, the screws
can be retrieved when the flue is removed (Step
16). Use a screwdriver or similar tool to free flue
cap from frypots. Remove flue cap by lifting up
and off of fryer.
11. Remove gas manifold pipe for access to gas
manifold shield by disconnecting at the unions.
Ensure gas supply is shut off and supply line is
disconnected prior to removing. Set gas manifold
aside. Remove screws securing gas manifold
shield. Remove shield to access oil-return
plumbing components connected to the frypots.
NOTE: For units without built-in filtration
skip the steps pertaining to removal and
replacement of oil-return plumbing.
12. Remove cotter-pin from oil-return actuator rod.
Observe washer placement prior to removing rod
from the valve actuator (arrows). Disconnect
actuator rod and remove washers. Set washers
aside for later re-assembly.
Removing flue cap.
Removing gas manifold shield.
Disconnecting oil-return linkage from valve.