Notice – Grizzly H6331 User Manual

Page 11

Advertising
background image

Model h6331 hVhp spray gun set

-11

-

6. adjust the fluid control knob to start with

a low volume of material and keep the
atomization as low as possible. you will
need to use a combination of fluid con-
trol, inlet air pressure, air flow control
and stroke speed to achieve the results
you want. spray so the material wets
out nicely without running or sagging.

7. use the pattern control knob to adjust

the spray fan to your desired pattern.

8. Keep the gun tip perpendicular,

equidistant, and 6-8" from the work (as
shown in

figure 4) when spraying. do

not allow your wrist to bend. this will
cause the gun to arc across the surface
and distribute the material unevenly,
possibly creating sags and dry spots.

9. Begin spraying 2-3 inches before the

workpiece and continue through the
end of the workpiece. Continue the
motion for a few inches past the work
until you are ready for the return stroke.

10. Maintain an even speed when spraying.

11. overlap each stroke by 50%. this will

ensure even coverage, as shown in
figure 5. overlapping less than 50%,
as shown in the figure to the right, may
lead to missed spots or streaky results.

NOTICE

tipping spray gun may cause material
to spill out of the cup. always hold
the spray gun perpendicular to the
ground to avoid potential spills and
gravity feed problems.

6"
8"

figure 4. spray technique.

6"
8"

figure 5. overlap technique.

12. the spray stroke should have even con-

sistency and parallel edges. if it doesn't
please refer to

troubleshooting on

page 16.

no

yes

contamination hazard! dispose
of paint waste in a responsible man-
ner! follow manufacturer's recom-
mendations and local laws regarding
disposal.

Advertising