Grizzly H6331 - Manual (Page 15)

Model h6331 hVhp spray gun set -15 -
lubrication 6. put on safety goggles, rubber gloves,
and rinse these parts thoroughly in
solvent, then dry with compressed air
or let air dry.
note: If the small holes in the atomizing
cap become blocked, soak in clean
solvent. If the blockage still exists, clear
the blockage with a small needle, tak-
ing great care to not enlarge or damage
the hole. Damage to the hole will create
a disrupted spray pattern.
7. use an old tooth brush with solvent to
clean the inner orifice and other hard to
reach areas on the outside of the spray
gun body.
8. Wipe the gun body with a lint free shop
towel to dry.
lubricate the following areas with
spray gun lube after cleaning:
a. atomizing Cap threads and gasket
b. pattern Control Knob
c. Fluid Control Knob
d. reservoir Quick release lever
e. reservoir gasket
f. trigger pin
after each cleaning, apply a thin film of
petroleum jelly to the needle spring before
reassembling.
figure 15. lubrication points.
a
F
d
e
B
C
figure 16. lubrication points.
a
B
C
d e
F