Grizzly H6331 - Manual (Page 14)

Model h6331 hVhp spray gun set -14 -
section 6: maintenance
cleaning
proper cleaning is the best way to ensure
trouble free performance from your spray
gun. if your gun is not thoroughly cleaned,
damage and poor spraying will result.
problems caused by improper cleaning will
not be covered by the warranty. Clean the
spray gun immediately after each use.
to clean your spray gun:
1. spray a small amount of solvent
through the spray gun.
note: Check with local laws regarding
this practice. Spraying solvents into
the air may be illegal in your area. A
cabinet style spray gun cleaner may be
required.
2. disconnect the gun from the com-
pressed air!
notice
do not soak the spray gun body
in solvent. prolonged exposure to
solvent will rapidly deteriorate the
spray gun washers and seals. ignoring
this notice will void your warranty.
eXplosion hazard! chlorinated
solvents like tricloroethane and
methylene chloride (methyl chloride)
can chemically react with aluminum
and may explode. many parts in
spray guns are made of aluminum.
read solvent label carefully before
using solvent.
3. remove the reservoir and lid.
4. disassemble the gun by unscrewing
the fluid control knob, then remove the
spring and needle (
figures 13 and
14).
5. unscrew the atomizing cap with your
fingers and the fluid tip with a wrench.
the fully disassembled gun should
look like
figure 13 and 14.
figure 14. large gun disassembled.
atomizing Cap
Fluid tip
spring
Fluid Control Knob
needle
lid
figure 13. small gun disassembled.
atomizing Cap
Fluid tip
spring
Fluid Control Knob
needle
lid
reservoir
Body
Body
reservoir