GE 29897 - Manual (Page 13)

13
S
ETTING THE
I
NCOMING
M
ESSAGE
L
ENGTH
This setting allows you to set the maximum length of time allowed for a single incoming
message. You can choose from 1-4 minutes.
1. If you just adjusted the Local Area Code menu, skip to step 2. If you haven’t adjusted any
other setting, press and release the MENU button until MESSAGE LENGTH is displayed.
2. Use NEXT or REVIEW or press the keypad number (1-4) for the desired setting.
3. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
S
ETTING THE
R
INGS TO
A
NSWER
This setting allows you to set the number of rings before the unit answers a call. You can
choose from 2-8 or Toll Saver (see “Toll Saver.”)
1. If you just adjusted the Message Length menu, skip to step 2. If you haven’t adjusted any
other setting, press and release the MENU button until SET RINGS TO ANS is displayed.
2. Use NEXT or REVIEW or press the keypad number (2-8, Toll Saver) for the desired setting.
3. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
T
OLL
S
AVER
Toll Saver can save you the cost of a call when you access your messages from
another phone:
• If you have new messages, the unit answers after the 2nd ring.
• If you have no new messages, the unit answers after the 5th ring.
You can hang up after the 3rd ring and save the pay telephone or long distance charge.
S
ETTING THE
S
ECURITY
C
ODE
This feature allows you to change the factory default remote access code used for remote
access to you answerer. The default code is 123.
1. If you just adjusted the Rings to Answer menu, skip to step 2. If you haven’t adjusted any
other setting, press and release the MENU button until REMOTE ACCESS is displayed.